======La lampe anti-conversation pénible======

===== Module Easyvr 3.0 et Arduino =====

  - **Pour envoyer des customs data depuis EasyVR Commander, jumper sur "UP"**
  - **puis jumper sur "Pc" pour récup le commandes custom du shield vers EasyVR Commander ...**
  - **pour téléverser sur arduino, jumper sur "SWW"**

**Pour téléversement, mettre le jumper sur HW**

==== Mode Jumper settings ====

This jumper selects the operating mode of the EasyVR Shield and it can be placed in one of four positions:

  * SW – Software Serial mode

Use it for controlling the EasyVR module from your Arduino sketch through a software serial port (using pins 12-13). You can also connect the EasyVR Commander in this mode, provided that the running sketch implements bridge mode (see the Arduino library examples).

  * HW – Hardware Serial mode

Use it for controlling the EasyVR module from your Arduino sketch through the hardware serial port (using pins 0-1).

  * PC – PC Connection mode

Use it for direct connection with the EasyVR Commander. In this mode, the Arduino controller is held in reset and only the embedded USB/Serial adapter is used.

  * UP – Flash Update mode

Use it for firmware updates or to download sound table data and custom grammars to the on-board flash memory from the EasyVR Commander. In this mode, the Arduino controller is held in reset and only the embedded USB/Serial adapter is used. The EasyVR module is set in boot mode.

  * LEO – Leonardo Update mode

This is similar to the regular Flash Update mode, for Arduino boards that don’t have a separate USB/Serial adapter, such as Arduino Leonardo. The EasyVR module is set in boot mode, but the Arduino controller is not reset and it must be running the special “bridge” sketch.

{{ youtube>7isZb8M7yN0 }}


{{tag>bj art_numerique}}